vociferous
Dirt Disciple
I'm trying to get my Grubb up and running, and noticed something wonky that that my Mk7 mech is doing: When I increase cable tension, the adjusting nut tips away from the body of the derailleur. If I try to re-tighten the adjusting nut, it simply compresses the springs more, and I'm left with the same situation. I have already tried replacing the large "taper tension" spring (the spring was bent when I removed it). Is the problem the volute spring needing replacement, or, perhaps, the spring locator cup that is out-of-position? I'm about at wit's end on this, and these mechs will go back in the box forever if I can't suss it out.
It appears the spring(s) are not supplying adequate counter-tension to the adjusting nut.
http://www.disraeligears.co.uk/Site/Cyclo_Benelux_-_The_First_Name_in_Derailleur_Gears_scan_2.html
It appears the spring(s) are not supplying adequate counter-tension to the adjusting nut.
http://www.disraeligears.co.uk/Site/Cyclo_Benelux_-_The_First_Name_in_Derailleur_Gears_scan_2.html