Amp Research B4 frame £200 posted final chance SOLD

[HarryCrumb]

Here we have for sale my AMP B4 frame. I left the outer cables on as these are full length through which I bought and cut for this frame using the original Amp down tube mounts. Also included are some spare mounts I had left and the original unused stickers from Amp (they have no more I have asked Brion at Amp). The original headtube decal has already been fitted. the frame is medium/small its hard to measure as all the front ends were the same and the bolt on section was changed for different size frame (Iam 5ft 7). I can supply you any dimensions you may need just ask. All the bushes are still tight and the shock is in good shape. the rear end has a canti stop which some don't so there are all types of brake option available for your build. All bushes and shock seals are still available from Brion Le Belle at Amp Research, so you dont have to be scared of getting a bit of mud and grit on things
I would like £200 posted for the frame, post and mech not included.

No swaps please and if you show interest on thread and then pm to confirm
Thanks.

Picture of frame built up on the Into the Void Retro Bike Ride

Pictures of stripped frame taken 13-10-2010

Pics showing the shock and spring, and measurements

[/b]

 

[donny70]

hadn't realised there was such damn nice machining on the swing arms of these... should be on the top side where you can see it.

Awesome example BTW.

 

[HarryCrumb]

hadn't realised there was such damn nice machining on the swing arms of these... should be on the top side where you can see it.

Yes beautiful machining

just for you a detail shot

 

[Chainsuck]

Sent you a PM!

 

[HarryCrumb]

pm replied, provisional dibs applied

 

[HarryCrumb]

pics showing dimensions now added

 

[HarryCrumb]

Dibs from chainsuck now removed due to lack of contact

 

[Wold Ranger]

Amp

Whats the seat tube int' dia' please and ext dia for mech thanks? Oh and any idea on frame and shock bare weight too?

 

[HarryCrumb]

Seat post size is 31.6

Front mech is 34.9 band clamp size, and is bottom pull

The spring and shock are taken from a "large" Amp B4 when the Risse shock was removed before I took ownership, so the spring rate should be higher than the small one it would have come with. If you note the close up of the shock there is a threaded section where spring/sag can be adjusted. Iam 10.5 stone and have it somewhere in the middle. I know that 12 stone is ok, as my friend had one.
other than that Brion Le Belle at Amp is very good for information and service parts.
Brion@amp-research.com

Hope this helps

 

[Wold Ranger]

Pm'd you

Pm'd you