57cm custom Chris Paulson 531 Tourer - Reduced again 18/03

velocipede

Senior Retro Guru
Built in 1988 with a nice spec as follows:

Handbuilt by Chris Paulson in sunny Rochdale!
531 frame with nice Prugnat cutout lugs, mudguard eyes, finished in nice flam blue paintwork. 57cm centre to top and with a 57cm centre to centre top tube (size updated 3/3/14)
Weinmann Centre Pull brakes
Dia Compe Aero levers
Cinelli 65-44 bars
Cinelli XA stem
Miche seatpost
Rolls saddle
Shimano 600 cranks (48-39), front & rear mechs and shifters
Fabulous wheels: Mavic sealed bearing hubs on Mavic MA40 rims with nearly new Continental Top Touring tyres
Campag pedals with clips and straps
SKS Mudguards and Blackburn rack

Not had much use in its life so on good condition - the frame has a few scrapes but no dents or damage

I'm after around £375 for it, collected from Cheshire NOW REDUCED TO £275 REDUCED AGAIN to £250 NOW REDUCED AGAIN (18/3/14) to just £225 collected from Delamere in Cheshire

12572197503_d9bcf70013_z.jpg

12572105665_c4664721da_c.jpg
 
Re: 23" custom Chris Paulson 531 Tourer - BIG PRICE DROP!

Hi,

What's the standover height?

Ta Rich
 
Re: 23" custom Chris Paulson 531 Tourer - BIG PRICE DROP!

hi richpips - just measured it now at 83cm from floor to top of top tube....I'm 5'10" and the seat height is perfect for me in the pics, although the stem is a bit long at 130mm; it would be perfect for me with a 100 or 110mm stem - I have a brand new NOS TTT one in 100mm that I can fit as an alternative
 
Re: 57cm custom Chris Paulson 531 Tourer - BIG PRICE DROP!

Thanks for the info. A bit too big for me.
 
Re: 57cm custom Chris Paulson 531 Tourer - Reduced again 18/

I'm sure whoever buys this will not be disappointed - who couldn't fall for a gorgeous set of Mavic sealed bearing hubs or a super condition Shimano 600 group set, let alone a custom built 531 frame?!
 
Back
Top