Spudalumps
Senior Retro Guru
Nice looking preferably 1 1/8
Wanted 24” wheel forks v break
- Thread starter Spudalumps
- Start date
Spudalumps
Senior Retro Guru
^
Bsmith#lts#
Dirt Disciple
Not got any but I used an old pair of pace forks and lowerd the brake mounts.. as I struggled to find decent 24inch forks
Spudalumps
Senior Retro Guru
Hey! Yeah I’ve seen that’s the go to, I’ve got a newly acquired 24” Zaskar I know they were stand fit with Ballistics although likely hood of finding them is zero to none
I've not got any forks I can help you with, but maybe some of the following options might help
1. Convert some pace forks. I had some rc31s converted to 24 inch by justbackdated. I was in talks with him about doing some rc39s at some point too but didn't go down that route in the end.
2. Cable disc front fork in 26 inch. I ran a dmr with full hydro brakes, 26 inch fork, 24 inch wheels.
3. Run a converter like this, dropping the brake mount on a 26 inch fork. https://www.ebay.co.uk/itm/28597437...ar=588055481478&widget_ver=artemis&media=COPY
4. A set of v brakes like these or similar that allow a fair bit of pad adjustment vertically: https://www.ebay.co.uk/itm/26704738...eEG02BlRb2&var=&widget_ver=artemis&media=COPY
I have a pair of the latter and I can check to see how low the pad can go if it helps. I have another set similar to Paul's which allow the pads the move up and down the whole shaft which might be an option, like onza holas too.
1. Convert some pace forks. I had some rc31s converted to 24 inch by justbackdated. I was in talks with him about doing some rc39s at some point too but didn't go down that route in the end.
2. Cable disc front fork in 26 inch. I ran a dmr with full hydro brakes, 26 inch fork, 24 inch wheels.
3. Run a converter like this, dropping the brake mount on a 26 inch fork. https://www.ebay.co.uk/itm/28597437...ar=588055481478&widget_ver=artemis&media=COPY
4. A set of v brakes like these or similar that allow a fair bit of pad adjustment vertically: https://www.ebay.co.uk/itm/26704738...eEG02BlRb2&var=&widget_ver=artemis&media=COPY
I have a pair of the latter and I can check to see how low the pad can go if it helps. I have another set similar to Paul's which allow the pads the move up and down the whole shaft which might be an option, like onza holas too.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
