Axeman1977
Old School Hero
I'll try and do a couple of sketches to show you what had been done. It was essentially welding on a web to reinforce the chainstay to pivot weld.
1999 Specialized Stumpjumper FSR XC Comp
- Thread starter Axeman1977
- Start date
roblobster
Dirt Disciple
instant boner. love these fsr and yet to get a frameset, just a bit unsure on the sizing. usually ride 18" on double diamond style frames and seen a few fsr in Large around, any idea of the fit? sorry, will do some more digging when time permits, was just wondering what you went for.
anyhow, bloody nice work, all thumbs up!
anyhow, bloody nice work, all thumbs up!
Axeman1977
Old School Hero
Not quite baby blue, it is called Regatta Blue!!
It is an 18 inch frame I think and I'm 6ft, possibly is a bit small for some but for me it works fine.
It is an 18 inch frame I think and I'm 6ft, possibly is a bit small for some but for me it works fine.
Axeman1977
Old School Hero
trickylad":cqr4n4vs said:
This is a quick sketch of the repair scheme that was undertaken.
The crack itself had grown down the lightening hole and the web was put in place for strengthening, also within the space where the wheel goes between the two chainstays some webbing was put in between the chainstay and the crossbrace leaving enough space for tyre clearance. Note on the drawing the dotted line, this was where i had to file back to to create clearance for the front derailleur when the suspension was compressed and the derailleur was on the smallest ring. The plate material used was about 5mm thick.
Hope this helps, I'll have to try and take some pics of the actual chainstay when I get a chance.
Axeman1977
Old School Hero
Olzster, thanks for the comments, as far as I knew Orange tend to powdercoat their frames now so I'm hoping that as it's good enough for them, then it'll be fine for me.
Shinobi, again thanks for the comments. The mech disc seem to work fine, better than my rims had worked anyhow. I went for the BB7's as they are adjustable on inner and outer pad. I was also limited as my xtr levers are combined and I didn't want to go to further expense!!
Shinobi, again thanks for the comments. The mech disc seem to work fine, better than my rims had worked anyhow. I went for the BB7's as they are adjustable on inner and outer pad. I was also limited as my xtr levers are combined and I didn't want to go to further expense!!
