1991-2 ish Gary Fisher E Stay (Montare or Hoo koo e koo)

Yes, I have most of the parts now just a few decisions to make about 8 speed or 9 speed.

Around 91' 8 speed was outlandish, 9 speed was otherworldly.

But Spinergy's were "WHAT THE" so they could warrant going 9.
Also having a nightmare getting metallic spray paint to finish the paint job, that was supposed to be the easiest part , pop over Halfords job jobbed. At the moment i am looking at Deco Colour Metallic sprays any other ideas?
 
Get that there drill out.
The rear spinergy has lost the freehub thread which is normally game over so a cunning plan. I have drilled the back out to 17mm by 8mm deep
20210615_201230.jpg
This recess gives me enough room for a 2mm thick top hat retainer for the bolt to lock onto.
20210615_201257.jpg 20210615_201241.jpg
Here you can see around 8mm untouched bore which will hopefully be enough cross section for any load on the end. GA cycles are on.the case for a new bare axle so next job is to make extra long cone nutscso they can be locked out side of the freehub body.
Also gave them a clean.
They will live again!
20210615_202818.jpg 20210615_202815.jpg
 
Back
Top