Headset press adaptors.

[Rampage]

I'm looking to make a load of these if there's enough demand. You can use them with your own threaded rod and nuts etc
£12 each plus postage, they will be ready in around 4 weeks.

The left one is for 1" & 1.1/8" headsets, it presses against the outer edge of the headset cup.

The middle one is for 1", 1.1/8" & 1.1/4" headsets. The downside is that some headsets are tapered or curved where this presses against so there isn't as much contact area and it might not be suitable for all headsets.

The one on the right just fits into the frame not a headset cup, so is only used when fitting the first cup.

 

[james1985]

Put me down for one, the one that does 1 & 1 1/8 please.

 

[Rampage]

Ok, is it just the one or a pair?

Just noticed the middle cup is side down!

 

[james1985]

Ok, is it just the one or a pair?

Just noticed the middle cup is side down!

Just the one will do me. Can you read Japanese?

 

[Rampage]

It's simplified Chinese, think it might be the same as Japanese?
I can't read it!

 

[james1985]

It's simplified Chinese, think it might be the same as Japanese?
I can't read it!

Cheers bud, when you know the postage etc, pm me details and will settle up.

 

[Rampage]

Will do.

 

[Rampage]

Bump or there's no point doing it bump.

 

[hamster]

Yes please! PM sent.

 

[Antstark]

Re:

i'd better have one of those too then....either the left or the middle one...whatever you end up making