Hi,
I'm working on a rear Pulstar hub. USA-made, not Taiwan. The drive-side bearing is shot. But to extract this (sealed) bearing, I had to remove the freehub, including the star part (don't know the name) that screws into the hub shell. This star part has 4 pins, 2.2mm diameter each with 26mm diameter between them. Should I go with a pin spanner ala Park Tool SPA-2 (or SPA-6 for an adjustable one) or rather something like the HCW-4? Or any tool that would plug in the star directly?
Thank for any advice!
I'm working on a rear Pulstar hub. USA-made, not Taiwan. The drive-side bearing is shot. But to extract this (sealed) bearing, I had to remove the freehub, including the star part (don't know the name) that screws into the hub shell. This star part has 4 pins, 2.2mm diameter each with 26mm diameter between them. Should I go with a pin spanner ala Park Tool SPA-2 (or SPA-6 for an adjustable one) or rather something like the HCW-4? Or any tool that would plug in the star directly?
Thank for any advice!
