FINISHED - Pace RC200 F1 with special RC35s. Pics on Page 6
- Thread starter Bollox64
- Start date
Re: Winter project started - Pace RC200 F2 with special RC35s
The Syncros was what I had available to throw-on so it would look more like a bike when it arrived
Now gonna be as much UK bits as possible - it's that damn sheeps' fault!
The Syncros was what I had available to throw-on so it would look more like a bike when it arrived
Now gonna be as much UK bits as possible - it's that damn sheeps' fault!
Skynet":csc9s914 said:
Re: Winter project started - Pace RC200 F2 with special RC35s
Small update.
Still need a new 112mm Action-Tec axle, as the idiots handling the shipping from Colarado lost the one I ordered - Bye bye 100 USD :facepalm: Cost to ship one tracked - 97 bloody Dollars :shock:
Plan B - get one shipped to our Office in Pennsylvania for 17 Dollars, and get a workmate to bring it over. To be continued...
On a happier note, the front wheel is now built up with the RC50 hub, though I had a clearance problem with the spokes hitting the pre-'93 RC35s...fixed using two copper washers
Slowwwly getting there.
also, on the shifter front, I think I'll be going with thumbies.
Small update.
Still need a new 112mm Action-Tec axle, as the idiots handling the shipping from Colarado lost the one I ordered - Bye bye 100 USD :facepalm: Cost to ship one tracked - 97 bloody Dollars :shock:
Plan B - get one shipped to our Office in Pennsylvania for 17 Dollars, and get a workmate to bring it over. To be continued...
On a happier note, the front wheel is now built up with the RC50 hub, though I had a clearance problem with the spokes hitting the pre-'93 RC35s...fixed using two copper washers
Slowwwly getting there.
also, on the shifter front, I think I'll be going with thumbies.
Bullpup
Senior Retro Guru
Re: Winter project started - Pace RC200 F2 with special RC35s
It seems to me that your skewer is not running through the centre of the hub - the skewer nut is sitting higher on the exterior of the dropout than the spacer is sitting on the interior. Is this just camera angle?
It seems to me that your skewer is not running through the centre of the hub - the skewer nut is sitting higher on the exterior of the dropout than the spacer is sitting on the interior. Is this just camera angle?
