deore dx running gear - vgc or better

[JaEdBa]

evening,

recently bought a 92 trek 8000. it has been built up with lx of the same era and dx thumbshifters.

I had one of these so know the original spec pretty much off by heart, after spending hours with the catalogue as a 14 year old... for some reason I decided I had to have the 8000 over the 7000, in today's money that's pretty much like me upspeccing by 3 month's salary for not a lot more..

anyway, in my quest to recreate my first bike I'd like a band on dx front mech M650 (31.9mm I think) and a dx rear mech MT-650. preferably in reasonably unblemished condition.

also I'm after a set of ST-M095 7 speed xt rapidfire brake / gear shifters, or xt thumbshifters. either in vgc.

if anyone did have a set of tange big forks in lunar...that's a long shot!

finally a matrix stem in 1 1/8 steerer 135mm or shorter.

thank you

 

[rc300]

check the size bud as i have these if any good

viewtopic.php?f=2&t=25698

 

[novekili]

were rapid fire push push or push pull? I have a pair of push pull Dx shifters/levers in vgc

 

[JaEdBa]

Re:

would still like:

black matrix stem - 135mm or shorter in 1 1/8 quill size, will consider silver control tech of the same dimensions - think I've seen one somewhere...

31.8 band on dx front derailleur, of the style that has a thin clamp with a 5mm allen bolt on the drive side - never understood the point of these but treks came with them.

thanks v much.

 

[rc300]

Re:

Pretty sure got a controltech stem. Will check in the morning

 

[paddlingpool]

Re:

you have pm re front mech

 

[JaEdBa]

Re:

thanks for the replies...

few remaining bits:

deore xt thumbshifters, ideally excellent or better.
deore dx quick release skewers
matrix 1 1/8 stem in 130 or 135 length, low rise without cable routing.

crazy to think I had boxes of these bits just sitting around in my parents' garage!

cheers

 

[rc300]

Re:

Hey not go on the controltech stem... Must have sold it only got a alloy uno stem hanging around