Cannondale coda rear free hub maintenance

jontyp

Dirt Disciple
I'm looking to bring a siezed freehub back to life from a F2000 but cannot find any instructions as to how to take the hub and freehub apart.

Before I see what happens when I take a hammer to the axle has anyone any ideas where I can find info on this?

Cheers
 
I may be totally wrong here, but there's every chance the coda hubs were rebadged DT-Hugi ones...
 
Thanks for the replies.

The hub is a coda expert, has an alloy axle and Ti freehub body. In the end I guessed it couldn't be too different to a hope xc hub so tapped the axle and bearings out to find the freehub screws to the hub body and needs a 12mm hex key to remove. Found the link below later so I'm hoping I can take it apart and replace the bearings.

http://singletrackworld.com/forum/topic ... e-freehubs
 
Sorry for reanimating this old thread, but does anybody know if Coda Expert hubs can hold 9- and 10-Speed cassettes?
 
Back
Top