Search results

  1. J

    Orange P7 rust on rear triangle thoughts

    I picked up some Rustins rust remover and had a go at it. Parts of it came up quite well but the side nearest the BB is very pitted and doesn't look great where the weld meets the chainstay. I took a few pics if you have any thoughts on those? I'm guessing based on the above I should probably...
  2. J

    Orange P7 rust on rear triangle thoughts

    Thanks for the advice this is really helpful will give that a whirl later this week and see how bad the damage is! Cheers 👍
  3. J

    Orange P7 rust on rear triangle thoughts

    Hi All, was just wondering if the rust on the bit that joins the two chain stays on the rear triangle is something I should be worried about? Also any suggestions on how to improve/seal it if possible. Thanks!
  4. J

    [Orange P7 1995] Combined seat post/saddle by design?

    Hi All, Another rookie question about my Orange P7! I assume this is the original seatpost and saddle, but they seem to be one piece? Not sure if I am just being really dense here, but there doesn't appear to be any way to remove the saddle except for bending the inner ring a lot, which seems a...
  5. J

    [Orange P7 1995] Shimano FC-M563 crankset -- self-extracting?

    Hi, Sorry if this is obvious but I just want to confirm before damaging anything -- am I looking at a self-extracting crank here? Is it a case of tightening what I think is a retaining ring and then using a hex key in the centre bolt to remove? I can see that the hex fitting is already quite...
  6. J

    Orange P7 bent dropout -- salvageable?

    Thanks all for your suggestions. Turns out it was just the mech hanger blocking the wheel, but in the end I managed to use a method (coincidentally outlined just after) which I came across online somewhere -- thread in a QR rear wheel and use as a lever to align the wheels and straighten the...
  7. J

    Orange P7 bent dropout -- salvageable?

    Cheers everyone for the really helpful suggestions -- glad to hear it's not as bad as I thought! I will try out a couple of the more DIY methods suggested on the mech hanger first and then go from there. Keep you posted!
  8. J

    Orange P7 bent dropout -- salvageable?

    Hi, I'm new to the site so hopefully this is the right forum. I recently got hold of an Orange P7 from I think '95 but clearly didn't do my due diligence and turns out one of the rear dropouts is severely bent (see pic attached -- hopefully that's clear enough). I'm assuming this isn't...
Back
Top