Recent content by Raumer

As said above the cable will push out. The easy way to do it is: Disconnect cable from the derailleur Push shifter the whole way out - away from the bar Push it back a bit and the end of the cable should pop out If not pull the outer away from the shifter and then push the inner cable in to...

I think that's a warranty replacement. The rear stays are the ones they used on the titanium dynatech's not the earlier steel ones. I have seen one before where it had the earlier colour scheme but was a later frame. Either way it is a bargain.

As it is a flat part (when laid on it's side) and not too thick I would go for getting it laser or waterjet cut. Then should be an easy job to drill it for the countersinking and through for the two mounting holes.

That is very nice. I've just bought a San Andreas, effectively frame and forks and needing cleaning etc... That was £500. But yours looks in very good condition and has the very desirable brakes and forks. I'd think around the £1500 or maybe more. If I hadn't just bought a house I'd happily...

Wow! Seeing one ex-team bike in good condition is unusual let alone two. Lovely to see them having survived and looking very original. There is a dynatech group on facebook and there is going to be a first meet up near Nottingham in a couple of weeks time if that is of interest to you. Out...

Definitely not shipping damage - two reasons, 1 I'm not sure that is possible by shipping!, 2 No impact or damage mark at either end of the crack. Agree with you that it is damage due to overtightening. Either not checked well enough or trying to pull a fast one.

You can run V brakes with standard levers so the same will go for the Marinovative. I never got on with V brakes using V brake levers so have only ever run them with cantilever brake levers. But you do need to run them closer to the rims and therefore your wheels need to be true.

Welded ones can sell for reasonable money. But agree on the paint finish and more importantly to me is that it is missing a front derailleur and a seatpost. Not easy or cheap to get those parts for a Manitou HT. I would be inclined to put it on ebay with the photos of when it was red as well...

A Specialized X23 rim that is cluttering up the garage. Has a slight bend in, hopefully visible in the first photo. Free for anyone who can make use of it. Collection only from NG8 (Wollaton, Nottingham)

Bump I do have some wheels with Hope Ti-glide hubs etc... that I could swap if that is of interest.

Very understandable! If you change your mind at all I've got a nice pair of Hope hubs on rims that are almost as nice that I could swap. Cheers Ed

If you decide to sell them I would be interested. Cheers Ed

Bump

Sadly those ones have sold. A shame as they were quite close to me and exactly what I am looking for.

I am looking for a pair of wheels, Shimano XTR M900 on BXC1 and BXC2 Bontranger rims. It's for a catalogue build so sadly only this combination will do. Thanks Ed